Spod 1997-2002 Instructions Center Bracket Manuel d'utilisateur télécharger pdf (Page 3)

8) Route the wires to the passenger side and down the pillar

through the dash (photo 8). Then re-tighten 3 pillar screws

loosened in step 4 & re-install visor.

Photo 8

9) Remove the glove box & route the wires out of the way

(photo 9).

Photo 9

10) Mark the lower right portion of the firewall for drilling

below glove box (photo 10).Drill a 1" hole in firewall. Be sure

to check the opposite side for any obstructions prior to

drilling (photo 10a).

Photo 10

Photo 10a

11) De-burr the hole and install the rubber grommet over

harness connector. Feed the connector & harness through

the firewall, then seat the grommet (photo 11).

Photo 11

1 2 3 4 5

Pas de commentaire

Spod 1997-2002 Instructions Center Bracket Manuel d'utilisateur Page 3